Bonding ceramic in paste heraceram kulzer non-precious metal reinforcement

Bonding Heraceram for non -precious ceramic reinforcement.

The Heraceram collage makes it possible to prepare the non -precious alloy surfaces for cosmetic covering.

Its objective is the prevention of uncontrolled excessive oxidation that can affect the connection between alloy and ceramics.

• Control of the oxide formation in non -precious metal alloys.
• The surface of the frame is perfectly covered by the opaque.
• Ceramic composition of glass, butane-1,2-diol.
• Practical advice: During cooking, water -soluble oxides can be formed in certain non -precious alloys causing yellowish ceramic products.
• To avoid these manufactured products, non -precious metal reinforcements must be rinsed specifically to water between each cooking stage.

When using Heraceram NP-Print, a specific cooling linked to the expansion of the non-precious metal alloy is no longer necessary.

• The Heraceram NP-Print dough is thixotropic.
• Shake or move before employment.
• Viscosity that can be readjusted by carefully increasing the Opaque Paste Heraceram Liquid (POL).
• The use of more fluid liquids of ceramic ranges made by other competitors is not indicated.

After the finish, the surface of the cosmetic covering of the non -precious metal reinforcement is sanded with disposable Corindon from 110 to 125 µm (al₂o₃, 3 to 4 bar).

• Clean carefully afterwards (for example using a steam cleaner).
• Oxidation cooking is not necessary.
• The Heraceram NP-Print Paste ready to use is applied in a very fine layer.
• Homogeneous material on the cosmetic cover surface of non -precious metal reinforcements.
• Use of an opaque paste brush and cook under vacuum.
• After cooking, the covered surface has a silky shine.
• The surface is thus prepared for the application of ceramics.
• Carry out the following steps in accordance with the instructions for using Heraceram, Heraceram Saphir or Heraceram Sun respectively.

General table of cooking:

Important note: the cooking temperatures are given as an indication. Greases are possible depending on the power and the model of the oven, so temperatures may need an adjustment.

• Drying minute: 2 min.
• Preheating: 1 min.
• Temperature increase: 100 ° C/min.
• Final temperature: 950 ° C.
• Maintenance time: 1 minute.
• Start of the void: 600 ° C.
• End of vacuum: 950 ° C.

No specific cooling speeds required for the NP-Print Heraceram.

Delivery : 1 x Heraceram ceramic bonding for non -precious - 2ml ready to use.